AIRTAC Angled HPA Adapter - GLK/ AAP-01 to M4

The perfect HPA adapter for CQB and speedsofters! The angled adapter runs the M4 magazine parallel to your wrist for a smaller vertical profile. 

Manufactured from impact-resistant Nylon 12 and Injection Moulded Polycarbonate

Fitting a Gas Magazine

To fit a gas magazine, use a 1.5mm hex key and unscrew the four screws on the inside of the M4 magwell (they are arranged in a square pattern).

Fit the included O ring to the top of the gas block of the adapter, in the O-Ring groove

You will then be able to access the screw hole needed to screw the adapter onto your gas magazine.

What if I have an EU line?

If you have an EU line, you can buy an EU fitting for the adapter here. Just unscrew the US fitting using a 3mm hex key, and screw in the EU fitting. 

Package Contents

• GLK Modular Top
• GLK Single Stack
• Angled Adapter Base
  
• 2*Magazine O-Rings

DO NOT EXCEED 150PSI WITH ANY AIRSOFT HPA ADAPTER.

ALWAYS USE AIR REGULATED BY A SECONDARY REGULATOR (EG AT200, WOLVERINE STORM, POLARSTAR MRS).

CHECK YOUR PSI BEFORE CONNECTING AIR TO A HPA ADAPTER.

NEVER CONNECT OUR EQUIPMENT TO PAINTBALL AIR TANKS OR CO2 TANKS.

NEVER CONNECT OUR EQUIPMENT TO A TIPPMAN STYLE HPA LINE